Filter
Top Products
24
Using the UltraKey Lite Controller
VideoBloX Key Functions
Note Use Figure 2-1 to locate each key as labeled in the ID column.
Note The keyboard supports dynamic key configuration. The key functions listed in
Table 2-2 are all default functions. Contact Honeywell Technical Support or
refer to the applicable VideoBloX manual.
To move back through the menus
one level at a time
•KEYS: Press Alt > Clr
To scroll through the top level
menu options
• LCD KEYS: Press the right/left arrow keys
• TOUCH PAD: Rotate your finger clockwise or counter-clockwise
• TOUCH PAD RING: Press the right / left arrows
• JOYSTICK: Move right/left
To scroll through the secondary
level menu options
You can use any of these ways to access the LCD:
• LCD KEYS: Press the up/down arrow keys
• TOUCH PAD: Rotate your finger clockwise or counter-clockwise
• TOUCH PAD RING: Press the forward/backward arrows
• JOYSTICK: Move up/down
To correct errors • KEYS: Press Clr
Table 2-2 VideoBloX Key Functions
ID Key Description Function in Camera Mode PCK (Cam Mode) PCK (Device Mode)
2 Alarm Acknowledge Alarms Alarm Ack Alarm Ack
3 Seq Selects Sequence mode SEQ SEQ
4 Iris – Iris close – Iris C Frame <
4 Iris + Iris Open + Iris O Frame >
5 Set Store a preset (preshot) Store Stop
6 Recycle (Undo) Undo previous camera selection
(NetCPU)
<- VCR F2
Table 2-1 LCD Menu Navigation During Set Up (cont’d)
Task Options