Filter
Top Products
44
Installing UltraKey Lite with VideoBloX
2. Under Serial Port1 Settings, select the following from each drop-down list as
required:
• Baud Rate: 1200, 9600, 19200 or 57600 bps.
The default for VideoBloX is 19200.
• Parity: none
• Stop Bits: 1 bit
• Data Bits: 8 bits
• Serial Mode: RS422
3. Click Apply to save the configuration, Cancel to exit without saving, or Default to
restore all factory default values.
Figure 3-11 Serial Port Configuration Tab
Step 3B: Configure the Controller for an Ethernet Connection
1. From the side menu, click IP Configuration. See Figure 3-12.
2. In each of the fields, enter IP address, subnet mask, gateway and DNS values.
3. Click Apply to save the configuration, Cancel to exit without saving, or Default to
restore all factory default values.
Figure 3-12 IP Configuration Tab