Filter
Top Products
6.1 INTRODUCTION, CONTINUED
The initial display after a user logs on the controller is shown below.
The operator has control of camera 1 and Spot Monitor 1 (multiplexer 1).
Tip: Press
+
and
–
to select the next or previous camera.
Tip: Press Monitor (
) followed by
+
or
-
to select the next or previous spot
monitor.
6.2 SPOT MONITOR OPERATION
The Spot monitor operates in two modes: Absolute and Relative. The HEGS5001 is in
absolute mode as shown below by default.
<Spot01 Cam001>
<Spot01 Cam001>
To toggle between Absolute and Relative modes, press the CAMERA key twice quickly.
Camera (
) Camera ( )
The SPOT still shows the multiplexer number while the CAM shows the input of that
multiplexer with an asterisk in front of the number.
<Spot01 Cam*01>
Rev. 1.01 44 900.0800
19-Jun-06