Filter
Top Products
4.3 MENUS, CONTINUED
KDZ SETUP
Menu Name Menu
Number
Description
KDZ Setup 4.0 Used to program the address of any KDZ connected to
the HEGS5000. Press Enter (
) to access this menu.
Serial No. 4.1 Using the number keys, enter the serial number of the
KDZ dome. Press Enter (
). The serial number is
supplied with the dome and is printed on the dome.
KD6-Z Addr 4.2 Enter the required address of the dome using the
number keys or
+
and
–
keys. Press Enter ( ).
Set Address 4.3
Press Enter (
) to confirm the information and send
the serial number and address to reprogram the KD6-Z
dome. Press Clear/Manual (
) to exit this menu.
Note: The above setup menu is simply a tool to allow the address of the KDZ dome to be
programmed from the controller. This information is not stored in the controller.
The address of each KDZ dome can be set one after each other without having to
exit this menu. Refer to the KDZ User Manual for detailed information on
programming and controlling a KDZ camera.
Passwords
Menu Name Menu
Number
Description
Passwords 5.0
Press Enter (
) to access this menu.
Master 5.1 Enter a new 4-digit master password. Once the digits
are entered, the password is reset.
Operator 5.2 Enter a new 4-digit operator password. Once the
digits are entered, the password is reset. Press
Clear/Manual (
) to exit this menu.
Outputs
Menu Name Menu
Number
Description
Outputs 6.0 An additional mutiplexer can be used to combine the
monitor outputs of multiple multiplexers to one monitor.
Press Enter (
) to access this menu.
Switch Dev 6.1
Switch Device – use the
+
and
–
keys to select the
type of multiplexer used to combine the monitor
outputs.
Press Clear/Manual (
) to exit this menu.
Address 6.2 Enter the address of the output using the number keys
or the
+
and
–
keys (001 to 255).
Rev. 1.01 16 900.0800
19-Jun-06