Filter
Top Products
5.2.12 Programming Sector IDs, continued
8. Enter the Sector title (up to 24 characters)
a. Press the + or – key until the desired character is displayed on the LCD screen,
and then press Character Select (
A
BC
). The controller sends the character to
the KD6/HD6.
b. Continue selecting characters and press Character Select (
ABC
) until the
desired title is displayed on the monitor.
c. Press Enter (
).
The following options are displayed on the monitor:
E to Edit Sector Press + or – key until E is displayed on LCD and
press Char Select. Repeat step 8.
D to Delete Sector Press + or – key until D is displayed on LCD and
press Char Select. The Sector # entered in step
6 is deleted.
S to Save Sector Coord. Press + or – until S is displayed on LCD and
press Char Select. Follow instructions in step 9.
N to Save Name only Press + or – key until N is displayed on LCD and
press Char Select. This option is used for
renaming Sector IDs. The title only entered in
step 8 is saved for the Sector # entered. The
current sector coordinates are not changed.
9. Press + or – until the character for the desired action is displayed on the LCD and
then press Character Select (
A
BC
).
To save Sector coordinates, press + or – until S is displayed on the LCD and press
Character Select (
A
BC
). Refer to the diagram below for programming
coordinates.
Right pan
Top tilt
Bottom tilt
Left pan
a. Using the joystick, move the PTZ so the lower left corner of the sector is
centered on the monitor, then press Enter (
).
Rev. 1.01 35 900.0800
19-Jun-06