42 105SL User Guide 6/4/2004 11342L Rev. 8
Configuration
Overview
Overview
After you have installed media and ribbon and printed a configuration label, you can change
the printer’s settings using the front panel controls. For an overview of the front panel,
including descriptions of the buttons and lights, see Operator Controls on page 3. If you need
to restore the printer to its factory default settings, see FEE D and PAUSE Self Te st on page 89.
Many printer settings may be controlled by your printer’s driver or label prepa ration software.
Refer to the driver or software documentation for more information.
Enter Setup Mode
To enter Setup Mode, press SETUP/EXIT. Press either NEXT/SAVE or PREVIOUS to
scroll to the parameter you wish to set.
Parameters in this section are shown in the order displayed when pressing NEXT/SAVE.
Throughout this process, press NEXT/SAVE to contin ue to the next parameter, or press
PREVIOUS to return to the previous parameter in the cycle.
An asterisk (*) in the upper left-hand corner of the LCD indicates that the value displayed is
different from the currently stored value.
Note • Printers that are operating on an IP network can b e quickly config ured in the fol lowing
ways:
• with the ZebraLink
®
WebView (ZebraNet
®
PrintServer II required). For information, see
the ZebraNet Networ king: PrintServer II Installation and User Guide.
• with the SetWLAN configuration utility (ZebraNet Wireless Print Server required). For
information, see the ZebraNet Wireless Print Server User Guide.
Note • You may also press and hold NEXT/SAVE and PREVIOUS to advance quickly
through the configuration parameters.
