A SERVICE OF

logo

Open as PDF
next previous
Printer Operation
Fanfold Media Loading
11342L Re v. 8 6/4/2004 105SL User Guide 29
Fanfold Media Loading
Fanfold media feeds through the bottom (Figure 20) or the rear access slot (Figure 21) of the
printer.
To load fanfold media, complete these steps:
1. Open the printhead.
2. Slid e the media guide as far from the printer frame as possible.
3. Load media as shown. If the printer is in Cutter Mode, route the media through the cutter.
4. Slide in the media guide so it just touches, but does not restrict, the edge of the roll.
5. Close the printh ead.
Note • A calibration must be performed when media and ribbon (if used) are first installed in
the printer, or when a different type of media or ribbon is being used.
Figure 20 • Fanfold Media Loading—
Bottom Supply
Figure 21 • Fanfold Media Loading—
Rear Supply