4 105SL User Guide 6/4/2004 11342L Rev. 8
Introduction
Operator Controls
Front Panel Keys
Table 1 • Front Panel Keys
Key Function
Starts and stops the printing process.
• If the printer is not printing: no printing can occur.
• If the printer is printing: printing stops once the current label is complete.
Press to remove error messages from the LCD.
Note • Pause Mode can also be activated via ZPL II (~PP, ^PP).
Forces the printer to feed one blank label each time the key is pressed.
• Printer not printing: one blank label i mmediately feeds.
• Printing: one blank label feeds after the current batch of labels is
complete.
Note • Equivalent to the Slew to Home Position (~PH, ^PH) ZPL II
instruction.
When in Pause Mode, this key cancels print jobs.
• Print job in queue: press once for each print job to be deleted.
• Press and hold for several seconds to cancel all print jobs in the printer’s
memory. The DATA light turns off.
Note • The following keys are used when configuring the printer. Speci fi c uses of these keys
are explained in Configuration on page 41.
• Scrolls back to the previous parameter.
•Press and hold to go backward quickly through parameter sets.
• Scrolls forward to the next parameter. (Saves any chan ges you ha ve made
in the configuration and calibration sequence.)
• Press and hold to advance quickly through p arameter sets.
Enters and exits Setup Mode.
The minus and plus keys change the parameter values. They are used in
different ways depending on the parameter displayed . Commo n uses are: to
increase/decrease a value; answer “yes” or “no;” indicate “on” or “off;”
scroll through several choices; input the password; or set up the printer for a
firmware download.
