Installing Or Replacing Parts And Accessories
Removing, Replacing And Upgrading Memory
Chapter 6
122
3. If you are installing additional memory
modules, you will need to remove the
continuity modules. Open the two retaining
clips and remove the continuity module from
the socket.
If you are replacing an existing memory
module, open the two retaining clips and
remove the existing memory module the
socket.
Always store any removed memory or continuity module in a safe place for future
use.
4. Install your new memory modules, ensuring
that the two notches on the bottom edge of each
memory module are aligned with those of the
socket. With the two retaining clips open, press
the memory module fully into the socket until
the retaining clips click into position. You can
also close the retaining clips by hand to ensure
that the module is correctly inserted.
5. Replace the workstation’s cover (refer to page 119). Reconnect all the power and
telecommunications cables.
6. Check the Summary Screen to verify the new configuration.
