Installing Or Replacing Parts And Accessories
Removing And Replacing The Cover And Front Bezel
Chapter 6
120
Removing The Front Bezel
The front bezel is divided into two sections:
• The upper bezel gives access to three 5.25-inch shelves and two 3.5-inch shelves.
• The lower bezel gives access to the control panel. To access the lower bezel, you must
first remove the upper bezel.
NOTE Take care when removing the upper and lower bezels. They are not on a hinge — do not
force them open.
To remove the upper and lower bezels:
1. Unclip the two clips located on the left-hand side of the bezel.
2. Open the bezel slightly, and then gently push it outwards. See Figure 6-4.
Figure 6-4 Removing the Bezels
Replacing The Cover And Front Bezel
1. Ensure that all internal cables are properly connected and safely routed.
2. If you have removed both sections of the front bezel, first replace the lower bezel.
Ensure that the bezel is correctly oriented, align the two plastic tabs with their slots
on the right-hand side of the chassis, and then close the bezel. After closing the bezel,
confirm that the tabs on the left side are fully seated flat against the chassis.
3. Standing at the back of the workstation, lower the cover onto the chassis (aligning
the guide rail on the bottom inside edge of the cover with the bottom edge of the
workstation chassis).
4. Shut the cover ensuring that the guides on the top of the cover slide into the rails at
the top of the chassis.
5. Slide the cover forward, then tighten the two thumbscrews.
6. If required, lock the cover using the key provided. Reconnect all the power and
telecommunications cables.
2
1
1
