1-36
36 | Setting Up the Printer
Configuring the Network Interface
You can configure the network interface using the control panel, as described
below, or using the EpsonNet Config utility, as described on page 46.
1. Make sure the printer is turned on.
2. Press the r
Menu button on the printer’s control panel.
3. Press d to highlight
NETWORK SETUP, then press r.
4. Press r then d to highlight
ENABLE.
5. Press . An asterisk appears next to ENABLE to show that it’s selected.
6. Press l then d to highlight
IP ADDRESS SETTING.
7. Press r and then u or d to choose one of the following IP configuration
settings:
•AUTO: Select this setting if your network uses a DHCP server to
configure your network devices’ IP settings automatically.
•PANEL: Select this setting if you would like to configure the
printer’s IP settings manually.
8. Press . An asterisk appears next to the setting you selected.
9. Press l to go back. Then do one of the following:
• If you selected AUTO as the IP ADDRESS SETTING, press the
Pause button to exit the printer menu. Then continue with
step 14.
• If you selected PANEL as the IP ADDRESS SETTING, continue
with step 10.
10. Press d to highlight
IP, SM, DG SETTING, then press r. The LCD
displays the IP address.
11. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press
r. The
LCD displays the subnet mask.
Note: If you don’t know
which setting to use, see
your network administrator
for help configuring the
printer’s IP settings.
