19
19
This chapter includes the following information:
• Unpacking and assembling the printer
• Connecting the power cord
• Installing ink
• Connecting to the network
• Installing the printer software
• Updating the printer firmware
• Configuring the printer for your network
Unpacking and Assembling the Printer
Follow these steps to assemble your printer and its stand. Before you begin,
select an appropriate location to set up and use the printer.
• Choose a flat and stable location that can support the printer’s weight
(about 331 lb, without the stand).
• Operate the printer under the following conditions: 50 to 95 °F (10 to
35
°C), 20 to 80% relative humidity, without condensation. In
addition, make sure the environmental conditions are appropriate for
the media you are using.
This illustration shows the minimum space required for using the printer:
WARNING: Avoid
locations that are subject
to excessive heat, poor
ventilation, or dust;
otherwise, smoke or fire
could result. Avoid
locations in direct sunlight
or near air conditioners.
Do not block the
ventilation openings. Do
not place the printer on a
carpet or rug, and do not
cover the printer with any
type of cloth when it is
operating. Leave at least
12 inches between the
back of the printer and the
wall. Do not place the
printer in an unstable
location; bodily injury may
occur if it falls.
Chapter 1:
Setting Up the
Printer
12 in.
12 in.
12 in.
75 in.
12 in.
27 in.
