Filter
Top Products
4
Setup the Repeater/Charger(s) (if included)
Connect the repeater/charger power cord
1. If your phone came with any
accessory handsets and
chargers, connect a charger AC
adapter to each charger's
DC IN 9V
jack and set the plug
into the notch as shown. (These
adapters might already be
connected.)
Plug the other end of the 2.
adapter into a standard 240V
AC power outlet.
Attach the stand
To attach the stand, you have to decide if you want the repeater 3.
to rest on a desk or hang on a wall.
For desktop use, turn the stand so the locking tabs that say
DESK
are facing the base with the arrows pointing up.
OR
For wall mount use, turn the stand so the locking tabs that say
wall are facing the base with the arrows pointing down.
Align the stand with the notches on the repeater.4.
Slide the stand onto the notches until it clicks into place. (To 5.
remove the stand, pull the locking tabs up and back. Then, slide
the stand straight off the same direction you put it on.)
Place the repeater/charger on the wall
For wall mount use, place the mounting slots (hole spacing is 6.
30mm horizontal) over the pins on the wall, and slide the base
down to lock it into place.