Filter
Top Products
31
Using the headset system
Pairing the headset to third party DECT GAP telephones
̈ Place the DW Pro1/Pro2 headset at a maximum distance of 1 m from
the third party base station.
̈ Simultaneously press and hold the headset’s LINK button ቦ and
AUDIO button ቧ for 5 seconds.
The headset switches to setting mode/GAP pairing mode and the
HE
ADSET LED ብ flashes blue/red.
̈ Set the third party base station to GAP pairing mode (see the instruc-
tion manual of the third party base station).
The headset pairs to the third party base station. If pairing was
successful, the HEADSET LED
ብ goes off.
The standard code for DW Pro1/Pro2 is “0000”.
Pairing is not successful If pairing is not successful within 60 seconds, the DW Pro1/Pro2 headset
switches to standby mode.
̈ For information on how to pair the headset to the third party base
st
ation, refer to the instruction manual of the base station.
Charging an additional headset
If you wish to charge an additional headset (heads
et b) in the base station
while you are using your headset (headset a):
̈ Make sure that a wireless link is established between headset a and
base stat
ion (the LINK LED ¿ on the base station lights up blue).
̈ Place haedset b in
to the base station.
Headset a can continue
to connect to and disconnect from the base
station and its use is not restricted while headset b is being charged.
If you leave the DECT range
If you leave the DECT range during a call, the audio quality deteriorates.
When the link breaks down completely, you hear a descending sequence
of beeps in the headset and the LINK LED ¿ on the base station lights up
red.
To resume the call:
̈ Re-enter the DECT range of the headse
t system within 60 seconds.
As soon as the headset re-establishes the wireless link to the
base
station, you hear a ring tone in the headset.
̈ Press the LINK button
ቦ on the headset to resume the call.
If you are using a handset lifter/electronic hook switch or if your
softphone supports call control, the call will automatically be ended
60
seconds after leaving the DECT range.