Filter
Top Products
4. You will see the screen below. Click on Allow.
5. Once initialization has nished, the SGC2910 Wireless PC Controller’ Install Wizard screen will appear.
6. After reading the notice, press the ‘NEXT’ button to begin the software installation. You should now see
the screen indicating that the software is being installed on your system.
7. Note: During installation of Windows Vista the following Windows security message will appear:
“Windows can’t verify the publisher of this driver software”. Please click “Install this driver software
anyway”.
8. In Windows Vista the SGC2910 Wireless PC Controller should be connected to your Computer before
beginning software installation. If the SGC2910 is not connected to your PC, the following message will
appear “Please Plug into the Wireless PC Controller”. If this message appears, plug the controller in to your
computer. You may need to wait a few seconds for Windows to load the HID drivers. Once completed,
you can click the “OK” button.
EN
Vista 32 Addendum
27
EN