Filter
Top Products
25
DC-1 Digital Controller
Installation and
Calibration
The DC-1 has the ability to load an effect whenever an input is chosen. For
example, if you primarily listen to CD’s with the CONCERT HALL effect,
the DC-1 can be set to load this effect when the CD input is chosen. (You can
listen to any effect using the EFFECT button on the front panel or the remote
control.) If you select USE LAST, the DC-1 will load the last effect used for
the selected input. Any effect can be assigned to any or all of the eight inputs.
The Dolby Digital version of the DC-1 will automatically switch to an
AC-3 effect whenever AC-3 encoded material is detected at the input. This
allows one input to be used for different formats. For example, in the factory
default state, the V-DISC input will automatically load the THX 5.1 effect
when an AC-3 signal is present, and the THX CINEMA effect when a non-
AC-3 signal is present. The default selections for input effect assignment are
shown below for all three versions of the DC-1.
Base THX Dolby Digital
Effect Effect non AC-3 Effect AC-3 Effect
VCR1 PRO LOGIC THX CINEMA THX CINEMA USE LAST
VCR2 PRO LOGIC PRO LOGIC PRO LOGIC USE LAST
V-DISC PRO LOGIC THX CINEMA THX CINEMA THX 5.1
TV TV MATRIX TV MATRIX TV MATRIX USE LAST
AUX PARTY PARTY PARTY USE LAST
CD MUSIC LOGIC MUSIC SURROUND MUSIC SURROUND USE LAST
TUNER NIGHTCLUB CONCERT HALL CONCERT HALL USE LAST
TAPE CHURCH CHURCH CHURCH USE LAST
* V-DISC is the only input which has an AC-3 effect assigned as a factory default.
The DC-1 remote control can be set up for direct access of as many as eight
effects. To assign these, first press the EFFECT button on the remote to scroll
to the effect you want to assign. Hold down the ACCY button on the remote
and press any one of the eight input buttons. The display will confirm your
selection.
EFFECT
ASSIGNED TO ACCY+ INPUT KEY
To directly access this effect (regardless of input), simply hold down the
ACCY button and press the corresponding input button.
To clear an effect from an INPUT button, press and hold ACCY. Press
BYPASS, then press the appropriate input button. The display will show:
EFFECT ASSIGNMENT
CLEARED
Input Effect Assignment