57
DC-1 Digital Controller
DC-1Effects
Party
The Party effect allows unprocessed stereo signals to be played over all
speakers for background music or for maximum acoustical output of the
system.
Parameter Initial Value Range
HIGH PASS 40Hz OFF, 40-735Hz
CENTER LEVEL 15 0-15
SUBWOOFER LVL +0dB -5 to +5dB
EFFECT LEVEL +00dB -30 to +05dB
CUSTOM
Party Parameters
HIGH PASS sets the level of a filter which removes low frequencies from the
center, side, and rear outputs. This is useful if the system is being used at
high volumes where low frequencies might damage smaller speakers.
CENTER LEVEL attenuates the level of the center channel as much as 15 dB.
A numerical value and horizontal bar are shown by the front panel and on-
screen displays during adjustment.
SUBWOOFER LVL boosts or cuts the subwoofer output level. Although the
normal subwoofer level is set during the calibration procedure, with some
recordings it may be desirable to increase or decrease this deep bass level.
EFFECT LEVEL adjusts the loudness of the center, side and rear speakers.
The Two Channel effect allows you to use your system for two channel
stereo playback.
Two Channel
Parameter Initial Value Range
SUBWOOFER LVL +0dB -5 to +5dB
CUSTOM
Two Channel Parameters
SUBWOOFER LVL boosts or cuts the subwoofer output level. Although the
normal subwoofer level is set during the calibration procedure, with some
recordings it may be desirable to increase or decrease this deep bass level.