Filter
Top Products
21
DC-1 Digital Controller
Installation and
Calibration
Display Adjustment
System
Configuration
Although the DC-1 memory is cleared before it leaves the factory, it is good
practice to reset the unit before programming it. The following procedure
resets the unit to factory condition:
Turn the DC-1 OFF with either the front panel switch or the remote. Turn
the unit back ON and immediately press and hold the BYPASS button on the
remote. (Make sure you do not block the infrared receiver on the DC-1 front
panel.) The display will read:
FACTORY PRESETS MENU
EXIT
RESTORE DEFAULTS
Use MENU ▲ or ▼ to highlight RESTORE DEFAULTS, then press SELECT.
This will clear and reload all preset effects and all factory settings of
Volume, Balance, Contrast, Configuration, etc. When the message FAC-
TORY DEFAULTS RESTORED is displayed, press DONE to return to
normal operation.
To adjust contrast, use SELECT to highlight CONTRAST ADJUSTMENT,
and MENU ▲ or ▼ to set the contrast of the display to its maximum as seen
from your listening position. Press DONE twice to return to the main menu.
Depending on the location of the DC-1 in your room, you may need to adjust
the front panel display for optimum viewing. To adjust this display, press
the MENU ▲, ▼ or SELECT buttons on the Remote to enter the Main Menu.
Press MENU ▼ twice to select DISPLAY ADJUST.
Press SELECT to highlight the Display Adjust Menu. Press MENU ▼ to
select FRONT PANEL DISPLAY.
If you want to turn the front panel display off, use SELECT to highlight
STATUS, then use MENU ▲ or ▼ to select OFF. Press DONE twice to return
to the main menu.