Filter
Top Products
11
DC-1 Digital Controller
Installation and
Calibration
6. BALANCE Front*/Rear*
and Left*/Right*
Display, then adjust the Front/
Rear and Left/Right level bal-
ances. Front and Rear con-
trols change the level bal-
ance between the front (Left,
Center, Right) and rear (L&R
Side, L&R Rear) outputs.
Left and Right controls
change the level balance be-
tween the left and right Front,
Side and Rear outputs.
7. Input Selection*
Individual buttons select from
8 inputs and activate a corre-
sponding green LED on the
front panel. Depending on the
Setup configuration, selection
may also load a new effect.
The Remote Control
8. RECORD/ZONE 2
Selects and deselects the
current input source for
RECORD and ZONE 2 out-
puts. When the REC/ZONE 2
function is engaged, red LEDs
are lit at the front panel REC/
ZONE 2 button and at the
selected source input button.
To modify the ZONE 2 output
without affecting other output
levels, press and hold
RECORD/ZONE 2, then ad-
just VOLUME.
Press MUTE while holding
down RECORD/ZONE 2 to
fully attenuate the ZONE 2
outputs. The ZONE 2 mute
status will be indicated by a
screen message. The attenu-
ation level of the ZONE 2
output mute is not user ad-
justable. Repeat to cancel
MUTE.
9. MENU*
SELECT, ▲ , ▼ and DONE
Allow access to and adjust-
ment of all displayed menu
items. (Volume, Bypass, Bal-
ance and Mute functions re-
main active in menu mode.)
MENU ▲ and ▼ step a dis-
play cursor through listed
menu items. SELECT dis-
plays submenus, or chooses
a menu item for adjustment.
The ▲ and ▼ buttons alter
the settings of selected pa-
rameters. DONE saves the
current changes.
Press one of the EFFECT
buttons, any Input Selector,
RECORD/ZONE 2, or any
BALANCE button to exit.
Press OFF to exit the menu
and enter standby.
10. ACCY
Provides accessory functions
when pressed in conjunction
with other remote buttons.
(See following page.)
1. OFF and ON*
Separate OFF and ON but-
tons are provided for learning
remotes, so that an auto-
mated key sequence does
not require information re-
garding the current on/off sta-
tus of the unit. OFF puts the
unit into standby with audio
muted, video blanked, the
LCD and all LEDs, except for
IR activity, turned off. The IR
LED remains illuminated and
the IR receiver remains ac-
tive. The selected input,
record status, current effect,
volume and balance settings,
and bypass state are saved.
2. EFFECT Up* and Down*
Display the current effect,
then step through all avail-
able effects.
3. BYPASS*
Puts the front left/right and
subwoofer outputs into ste-
reo bypass. The stereo ana-
log or digital inputs are fed
unprocessed to the front left/
right and subwoofer amplifier
outputs while all other ampli-
fier outputs are muted. A front
panel LED will light yellow
and screen messages indi-
cate bypass is engaged.
4. MUTE*
Attenuates all audio outputs
except for RECORD/ZONE
2, lights a red front panel LED,
and displays a screen mes-
sage. Attenuation level can
be set in the Setup menu.
5. VOLUME Up* and Down*
Display the current volume
setting, then adjust all out-
puts, except RECORD and
ZONE 2. Screen displays
show a volume bar and level
in dB.
*In standby, pressing turns the unit on.