Filter
Top Products
24
SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev14
Commissioning
Commissioning Process
EXPLOSION OR FIRE HAZARD
Entering battery information incorrectly may result in
explosionorre.
During commissioning, the SMARTBOX™ Controller and turbine must be set up.
Settings for the battery type, battery banks and battery capacity must be set up in the
SMARTBOX™ Controller, and the turbine’s components will need to be tested. This
testing can be done with the control panel and LCD screen on the front of the system
controller. Ensure you have this system information prior to commissioning. The
commissioning process will reference menu displays.
The following is the proper procedure to commission the turbine. Do not proceed
with commissioning until all disconnects are in the off position and the turbine is
mechanically locked. The turbine dynamic brake will remain enabled up until the
turbine disconnect step.
The following is the proper procedure to commission the HONEYWELL™ Wind
Turbine. Do not proceed with commissioning until ALL DISCONNECTS are in the OFF
position and the turbine blades rotate freely.
1. Check all connections for polarity.
2. Apply battery power to the unit with the disconnect or selector switch inside the battery
enclosure.
3. The LCD display will light up and prompt a display:
Display Description
WINDTRONICS RX.XX
FIRST POWER UP
The Smart Box will display this for
5 seconds and then move to the
required setup information.
4. The system will automatically walk you through the commissioning process. All steps
must be completed before the turbine will operate. If problems are found during this
process, the battery disconnect can be turned off at any time to restart the process. All
of the settings will be saved, but you must start over and go through all the steps until
commissioning is complete.
5. For optimal performance it is important to enter optimal battery information
(steps 5-7). We highly recommend using two 12V deep cycle/ooded/marine
100Ahr batteries. For this selection please enter the following optimal settings
for best performance.
Attherstpromptscreen,selectthebatterytypebyusingthearrowkeys.
PressENTERwhennished.
Display Description Optimal
ENTER BATTERY TYPE
FLOODED
Set the battery type Flooded