Filter
Top Products
8494/95/96G/H Operating And Service Manual 11
Installation
Installation
Instructions
The attenuators may be installed with or without the base. The base is
removed by unscrewing the two fillister head screws from the bottom of the
base. The attenuator may be mounted without the base by inserting two 4-40
screws into the screw holes in the bottom of the attenuator. Removing the
base and mounting the attenuator does not affect the performance of the
attenuator.
The solenoid drive cable connector plug is connected to the attenuator by
aligning the plug (Pl) with the jack (Jl) on the attenuator, and then pushing
the plug over the jack. The plug is removed by grasping the ribbed sides of
the plug and squeezing them together while pulling back until the plug clears
the jack.