Filter
Top Products
20 WIRELESS LAN SWITCH AND CONTROLLER MSS VERSION 6.0.4.6 RELEASE NOTES
Known Problems
System Configuration Issues
Adding a static VLAN with the same name as a
VLAN whose traffic is being tunneled through
the switch can cause the switch to restart.
(18367)
MSS can tunnel traffic for a VLAN through a WX
switch that does not have that VLAN statically config-
ured. If you attempt to add a static VLAN to a switch
that is already tunneling traffic for a VLAN with the
same name, the switch can restart.
To create the VLAN, clear the Mobility Domain config-
uration from the switch, create the VLAN, and then
configure the Mobility Domain again.
The default value for RADIUS “deadtime” shown
in the CLI help is incorrect. (41689)
The correct default value is 0.
When upgrading systems with large
configurations, it may be necessary to save the
configuration to a backup file. (41330)
When upgrading systems with very large configura-
tions, for example, hundreds of APs or hundreds of
users, it may be necessary to save the configuration to
a backup file, generate a minimal configuration, per-
form the update, load the backup configuration from
the command line, and then save the configuration.
Time and date do not synchronize with an NTP
server, if the switch's NTP client is enabled
before the NTP service is started on the server.
(20382)
Using set ap <apnum> boot configuration
commands. (38517)
The set ap <apnum> boot-configuration switch
switch-ip cannot be set at the same time as set ap
<apnum> boot-configuration switch name
<switch-name> dns <ip addr>. The commands
overwrite each other when used.
The auto-config feature does not work properly
if the 3WXM server is unreachable when the
auto-config feature is enabled. (44477)
To work around this issue, be sure that the 3WXM
server is reachable from the wireless switch before
you enable auto-config. If auto-config is enabled by
default on the wireless switch, be sure that the
3WXM server is reachable before you boot the wire-
less switch.
Active AAA sessions (clients trying to
establish active connections) per WX
switch
WX4400: 2500
WX2200: 3200
WX1200: 300
WXR100: 75
These are the suggested maximums.
The switch might be able to support
even more sessions, but performance
or system stability might be affected.
AAA users configured in local data-
base
WX4400: 999
WX2200: 999
WX1200: 250
WXR100: 250
Client and Session Parameter Supported Value