© Adam Equipment Company 2011 Page
22
6.4.3 RECALLING PLU’S MANUALLY
• To recall the PLU values the user should first select either local or
remote scale as the tare value stored will be specific to the scale
selected.
• Then press the [PLU] key, enter the PLU number (00 – 99) then press
the [PLU] key again to recall the data.
• The display will show the results of the recall for 1 second then return
to weighing with the data in place.
For example:
• If the [PLU] key is held down after the numeric entry, it will show the
description as long as the key is pressed.
• In this example the display “PLU 27 ” “M 4 Nut“ “Brass “ shows the
description for 1 second, if no data is stored then it will show
“nO ” “ PLU “ “SAVE “.
• If the tare value is outside the range permitted for the selected scale
(For example, if the local scale is selected whereas the tare value
applies to the remote scale, this would exceed the capacity of the local
scale) the “Weight” display would show zero tare weight.
• If the tare value stored does not match the increment of the selected
scale (For example, storing -1.446 for a scale with d=0.05) then round
the tare weight depending on the scale resolution (For example, in this
case, -1.45 would be used as the tare value).
ACTIONS DISPLAYS
Press [PLU]
“PLU ”
“ - -“ “ “
Press [2], [7]
“PLU ” “ 27” “ “
Press [PLU]
“PLU 27 ” “M 4 Nut“
“Brass “
After 1 second, it will return to
normal weighing with the Tare
and Unit Weight previously
entered.
“ x x x x“ “ x x x x ”
“ x x“
