Filter
Top Products
–
14
–
Part 2 Learn signal from Control Panel to Control Module
HOME AUTOMATION
Control Module [1] is represented by zone LED 1
CONTROL MODULE
LOCATION
1 6
2 7
3 8
4 9
5 0
TRANSMIT
BUTTON [X]
1
2
Enter
Programming
mode
LED on the Control Module
will flash indicating it is in
learn mode.
[6] to [0]
Transmit an ON
signal for the
selected device
from the Control
Panel to the
Control Module.
Refer to the
chart below to
determine which
button [6] to [0]
to press.
You should
transmit the “ON”
command for the
selected device.
After [X] is entered, you
will hear [Device X On]
indicating you have trans-
mitted an ON signal for
device X, where X is the
Control Module Location.
The LED on the Control
Module should be off,
indicating it has learned
the signal, you may now
release the learn button
and the LED will stay on
again.
Press and hold
the learn button
on the Control
Module until its
LED starts to
flash.
Step Keys Function Description Note
–
39
–
This row :
Buttons for
Learning Control Module
INSTALLATION
Deactivating the Digital Dialer
You can deactivate the digital dialer by erase the phone number memory for
central monitoring station.
Press [PROG]
Press [MPIN]
Enter Program-
ming mode
Press [1]
Enter master
password to
programming mode
3 beeps for valid
password. 1 long
beep for invalid
password.
You will hear:
[Enter Phone
Memory]
Select phone
number
programming
Press [0] Enter phone
memory
Step Keys Function Description Note
4
3
2
1
Press [ARM] You will hear
[Phone Zero
Empty Memory]
indicating the phone
number have been
deleted, the digital
dialer is deactivated.
Confirm delete
the phone
number.
®
Note: If no phone number is programmed to call the central monitoring station,
the digital dialer is automatically disabled.