Filter
Top Products
Configuration Guide
PN: 1725-36071-001_C.doc
6
Initial Setup
1. The following instructions are for configuring a wireless controller
and a number of access points with no prior configuration.
2. All of the initial setup is done via a web interface. Connect a
‘Cross-Over’ Ethernet cable directly from the Management Port of
the controller to a PC’s Ethernet port.
3. Log onto the controller by opening a web browser and connect to
https://192.168.10.1:5825/. The default username is
admin; the
default password is
abc123.
4. Do this step only if it is necessary to reset the controller back to its
factory default configuration:
a. Click the
Wireless Controller button to open the Wireless Controller
Configuration
screen.
b. In the navigation pane, click
System Maintenance.
c. Click the
Reset database to factory default and reboot button.
d. Click the
Apply button.
This will reset the database and cause the controller to reboot.
It will take three to four minutes before the controller is
finished.