Filter
Top Products
26
27
Using the Nunchuk
Using the Nunchuk
Holding the Nunchuk and Wii Remote Plus Disconnecting the Nunchuk
Press the Lock/Release Levers on the sides of the Nunchuk plug and pull the plug
straight out of the External Extension Connector on the bottom of the remote.
IMPORTANT: Make sure the
wrist strap cord runs through
the connector hook.
Lock/Release Levers
Squeeze levers to remove
plug from Wii Remote Plus.
Troubleshooting (Before seeking assistance, review the following problems and solutions.)
No picture on TV screen
• Make sure you have completed all steps, in the order that they appear, on the Quick
Setup sheet included with your system.
• Make sure that all components of your setup are plugged into power outlets and that
all components are turned ON.
• Make sure that cable connections are correctly installed and that all plugs are
securely plugged into the appropriate connectors.
• Make sure that the INPUT settings are correct for your particular setup. (Review page
15 on Input Select information.)
No sound is heard or sound quality is poor
• Make sure the TV volume is not turned off or muted.
• Make sure that all audio connections are correctly installed and that all plugs are
securely plugged into the appropriate connectors.
• Make sure the Wii AV Cable is plugged into the “input” connectors on the
TV or VCR, not the “output” connectors.
• Make sure that the INPUT settings are correct for your particular setup. (Review
page 15 on Input Select information.)
• The sound in some games doesn’t begin until the game begins.
• If you have a mono TV or VCR and have left one of the audio cables unconnected
you may not get all game sounds. Use a “Y” Adapter to get both left and right
sound channels.
• If your TV/VCR have both mono and stereo options, make sure they match your setup.
• Check the instruction booklet for the game you are playing to see if there are volume
controls or mono/stereo options that can be set from within the game.
Can’t get past the Language Select screen
• Synchronize your Wii Remote Plus controllers using the procedure on pages 19–22.
• Review the Sensor Bar setup instructions on pages 11–14 to ensure proper placement
and installation.
The console Power LED does not come on, or goes off
during game play
• Make sure the AC Adapter is plugged into both the wall outlet and the back of
the console.
• If the light is still off, disconnect the AC Adapter plug from the wall outlet, wait 2
minutes and plug it back into the outlet. Turn the console power ON.
System unable to read the Wii Game Disc or disc will
not operate in console
NOTE: Game Discs will not start automatically. You must start disc games from the Disc
Channel on the Channel Menu screen.
• Make sure the Game Disc is inserted correctly. The label side of the disc must
face upwards.
• Check to be sure that the Game Disc is clean and in good condition. If dirty, wipe
with a soft cloth, from the center to the outside. Do not wipe with a circular motion.
• Remove the Game Disc, and turn the power OFF and then ON. Reinsert the disc and
try playing the game again.
• Check that the Game Disc will work on your version of the Wii. This system will only
work with Game Discs made for use in the USA, Canada, Mexico and Latin America.
Troubleshooting