Filter
Top Products
IW4/IW7 WB/WBV Operations
D1 0412BA1-GB04 27
After exiting the roller set and storing of the measurement values the rotational direction reverse
is immediately deactivated. The test stand is in the Automatic mode again.
3.10 Special Points about the Hongkong Mode
Test stands with the Hongkong mode one side will continue to measure even once the other
side has switched off via slip. The other wheel will be blocked at a later point in time due to the
pedal force being raised.
Test Procedure
Switch on the test stand and and wait for ready-to-test.
1 Drive onto the rollers.
2 Rollers start up.
3 Brake slowly until one roller side has reached slip.
Either the left or right hand side will switch off.
The respective pointer falls back to zero.
4 Slowly continue to brake until the other roller side has reached slip.
Either the left or right hand side will switch off.
The respective pointer stops and the other pointer shows the first brake value.
Slip is too small:
The roller does not switch off.
Release the brake.
Store the max. value using the corresponding key combination on the remote control.