Filter
Top Products
Operations IW4/IW7 WB/WBV
26 D1 0412BA1-GB04
3.8 Special Points about the Portugal-Mode
Select weight transfer
Test stands with the Portugal-Mode are equipped with a selection switch
with which the weight transfer can be selected. (in unoccupied test
stand) :
Position A: Weight of the axle (for TRK) is measured via the brake tester
(internal scale).
Position B: Weight of the axle (for Car) is measured via the shock
absorber tester (external scale) and transferred to the brake tester.
3.9 Special Points about the Sweden Mode
The Pseudo 4 wheel drive measurement can be done using the special rotation direction
reverse on test stands with the Sweden mode.
Test Procedure:
1. In unoccupied test stand press the key combination SHIFT + D on the remote control to
activate the rotation direction reverse and/or manual operation.
Following message appears on the display:
2. Confirm the rotational direction reverse with
the *-key on the remote control.
Deactivate the rotational direction reverse
again using the #-key on the remote control.
3. Drive onto the test stand.
Following message appears on the display:
4. Press the left Motor-On key of the remote
control.
Both motors start simultaneously, counter clockwise. The selected side rotates in a forward
direction.
Conduct the measurement.
If slip is reached the motors switch off.
If slip is not reached , the motors must be switched off using the Motor Off key on the remote
control.
The right side is measured after the left hand
side.
Following message appears on the display:
5. Press the right Motor On key on the remote
control.
Both motors start up simultaneously, counter clockwise. The selected side rotates in the forward
direction.
Conduct the measurement.
If slip is reached the motors switch off.
If slip is not reached , the motors must be switched off using the Motor Off key on the remote
control.
6. After the motors have switched off the measurement values are shown on the display.
Store the measurement value using the appropriate key combination. (see the operating
manual of the remote control).
D R E H
K E H R
* = J A # =
N E I N
D R E H
K E H R
L I = V O R W
Ä R T S
D R E H
K E H R
R E = V O R W
Ä R T S
D R E H
K E H R
L I = V O R W
Ä R T S