Filter
Top Products
3 Cisco 6100 Series System Cables 78-6643-01 09/27/99
Cisco 6100 Series User Guide3-4
3.2.1 MC to PSC Cables
You can use the following cables when you are cabling the MC to the PSC in a Direct Connect with
a PSC configuration:
• One-to-one cables—Used to connect the MC to the PSC for systems using dual-port CAP or
DMT-2 ATU-C modules. This cable is not recommended if you plan on expanding your system
to quad-port xTU-C modules, which will be available in a future release.
• Two-to-one cables—Used to connect one MC to two PSCs for systems using dual-port and
quad-port ATU-C modules. Quad-port ATU-C modules will be available in a future release.
One-to-One Cables
You can use one-to-one cables to connect the MC to the PSC for systems using dual-port CAP or
DMT-2ATU-Cmodules. Table 3-2lists the backplane connectors andthe part numbers for thebasic
one-to-one cables connecting the MC to the PSC in a Direct Connect with a PSC configuration.
Note Do not use this cable if you plan to expand the system to quad-port xTU-C modules, which
will be available in future releases.
Note When you use the one-to-onecable, see Table C-1 on page C-2 for port mapping information.
Table 3-2 Connectors and Part Numbers for One-to-One Cables—MC to the PSC
Connections
Backplane Connector Cisco Part Number
NetSpeed Part
NumberMC PSC Kit Subassembly
J39 J3 CAB-61-014 72-1665-01 4100-021-01
J40 J1 CAB-61-014 72-1665-01 4100-021-01
J41 J5 CAB-61-014 72-1665-01 4100-021-01
J42 J4 CAB-61-014 72-1611-01 4100-021-02
J43 J2 CAB-61-014 72-1610-01 4100-021-03
J44 J6 CAB-61-014 72-1609-01 4100-021-04