Filter
Top Products
78-6643-01 09/27/99 Cisco 6100 Series System Cables 3
Cisco 6100 Series User Guide 3-13
Figure 3-12 shows the cabling between the MC and the MDF in which the cables listed in Table 3-6
are used.
Figure 3-12 MC to MDF Cabling Diagram with Two-to-Three Cables
3.3.2 Three-to-Three Cables
To associate the MDF wire pairs and the MC modem ports, the three-to-three cable remaps the wire
pairs from the MC connectors to the MDF connectors. Use the cable in systems with dual-port
DMT-2 ATU-C or quad-port xTU-C modules installed in the MC. Table 3-7 lists the backplane
connectors and the part numbers for the three-to-three cables connecting the MC to the MDF in a
Direct Connect without a PSC configuration.
Note When you use the three-to-three cable, see Table C-5 on page C-14 for port
mapping information.
Table 3-7 Connectors and Part Numbers for Three-to-Three Cables—MC to MDF
Connections
Backplane Connector Cisco Part Number
MC MDF Kit Subassembly
J39, J40, J41 P4 (slots 1 to 6),
P5 (slots 7, 8, and 21 to 24),
or P6 (slots 25 to 28)
CAB-MC128-MDF 72-1765-01
(right cable)
J42, J43, J44 P1 (slots 13 to 18),
P2 (slots 19, 20, and 31 to 34),
or P3 (slots 35 to 38)
CAB-MC128-MDF 72-1720-01
(left cable)
MDF
connections
Cisco 6130
27321
P14
P17
P15
E2A VISUAL AUDIBLE
FAN
ALARM
MIN
MAJ
CRIT
ACO
MIN
MAJ
CRIT
ACO
MIN
MAJ
CRIT
ANALOG TEST I/F
RING
TIP
P18
-48V_B
-48RTN
-48V_A
-48RTN
P13
MODEM
POOL
A
OUT
J45
J48
P3P9
J39
J42
MODEM
POOL
B
OUT
J46
J43
J44
J41
J40
J47
J49
P2
J1
Fan tray
FAN
P2
J1
-48VA
RTN
-48VB
RTN
MDF
connections