Filter
Top Products
78-6643-01 09/27/99 Cisco 6100 Series System Cables 3
Cisco 6100 Series User Guide 3-25
3.6 Siecor POTS Splitter Cables
The Siecor ADSL POTS Splitter Rack-Mount Shelf is compatible with the Cisco 6130. If you use
the Siecor POTS splitter, you need six one-to-one cables to connect the POTS splitter to the Cisco
MC connectors J39 through J44.This one-to-one cable is not the same asthe one-to-one cables used
in previous configurations.
Use the one-to-one cable when you are connecting the MC to the Siecor POTS splitter. Table 3-12
lists the cable and associated part numbers.
Note When you use the one-to-one cable, see Table C-9 on page C-29 for port
mapping information.
Figure 3-26 shows the one-to-one special cable.
Figure 3-26 One-to-One Special Cable
Note If you are installinga Direct Connect with a PSCconfiguration using the Siecor ADSL POTS
Splitter Rack-Mount Shelf, install the Cisco components (excluding the PSC) according to the
Cisco 6100 Series Direct Connect Installation Guide. Refer to the ADSL POTS Splitter Rack-Mount
Shelf Central Office Version document for installation procedures for the Siecor POTS splitter. This
configuration is only compatible if DMT-2 ATU-C modules are installed in the MC and
DMT modules installed in the Siecor POTS splitter.
Table 3-12 Connectors and Part Numbers for One-to-One Cables for the Siecor POTS
Splitter
Backplane Connector Cisco Part Number
MC Siecor POTS Splitter Kit Subassembly
Connectors
J39 to J44
Connector CAB-6121-1 72-1766-01
23704
P1
P2