Filter
Top Products
Setup
Q-Spot™ 560-LED User Manual Rev. 06 -7-
3. Setup
AC Power
The Q-Spot™ 560-LED has an auto-ranging power supply that works with an input voltage
range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this manual or on the product’s sticker.
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
To determine the power requirements for the Q-Spot™ 560-LED, refer to the label affixed
to the side of the product. You can also refer to the Technical Specifications chart in the
Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation. For
more information, you may download the document Sizing the Circuit Breakers from the
CHAUVET® website: www.chauvetpro.com.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
The Q-Spot™ 560-LED comes with a power input cord terminated with an IEC connector
on one end and an Edison plug on the other end (US market). If the power input cord that
came with your product has no plug or you need to change the Edison plug, use the table
below to wire the new plug.
Connection Wire (US) Wire (Europe) Screw Color
AC Live Black Brown Yellow or Brass
AC Neutral White Blue Silver
AC Ground Green/Yellow Green/Yellow Green
Fuse Replacement
This product uses a T 5 A, 250 V fuse.
Make sure to disconnect the product’s power cord before replacing a blown fuse,
and always replace with a fuse of the same type and rating.
1. Disconnect the product from the power outlet.
2. Wedge the tip of a flat head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing to pull out the installed fuse.
4. Remove the blown fuse from the safety cap and replace with a fuse of the exact same
type and rating (T5 A, 250 V).
5. Insert the fuse holder back in place and reconnect power.
Installedfuse
(heldbyplasticclip)
Sparefuse
(insidesafetycap)
Safetycap