Filter
Top Products
E-10
Using Built-in Tones
3.
Use the
ck
to
cr
(tone groups) buttons to
select the group you want.
Example: To select the ORGAN group
4.
Use the
bt
(w, q) buttons to select the
tone you want.
Example: To select “002 Jazz Organ”
NOTE
• Pressing q and w at the same time will jump to
tone 001 of the currently selected group. Holding
down either button changes the tone number at high
speed.
• See page E-40 for more information about scrolling.
You can layer two different tones so they play at the
same time when you press a keyboard key.
• The first tone you select is called the “main tone,”
while the second tone is called the “layered tone.”
1.
Select the main tone.
Example: To select MELLOW PIANO in the CLASSIC
group, press the
cl
(CLASSIC) button and
then use the
bt
(w, q) buttons to select
“002 Mellow Piano”.
2.
Hold down the button of the group that
contains the tone you want to select as the
layered tone until “LAYER: ON” appears on
the display as shown below for a few
moments.
This will layer the tones currently selected in the two
groups.
The button you held down in step 2 will light to
indicate that it is selected.
Example: When BASS/GUITAR group is selected
3.
Use the
bt
(w, q) buttons to select the
tone you want in the group you selected in
step 2.
Example: When “006 Picked Bass” is selected
4.
To unlayer the tones and return the keyboard
to a single tone, press any one of the tone
group buttons.
NOTE
• You can adjust the balance between the main tone
and layered tone. For details, see “Layered Tone
Volume (Layer Balance)” (page E-41).
Layering Two Tones
Lit
Tone number
Tone name
Lit
Layered tone number
Layered tone name