Filter
Top Products
Installing Vanguard Multiport Hardware
3-2 Vanguard Multiport 4520CP Controller User’s Guide
Installation Overview
This section provides an overview of how to install your Vanguard Multiport con-
troller and the Aurora device drivers.
Step 5 is only required if you are installing a synchronous protocol pack-
age such as X.25.
Before beginning the installation, record the following information in the Product
Information Worksheet at the back of this manual.
• Vanguard Multiport card serial number
• Rear I/O card model and serial number (if applicable)
• The name and model number of the system into which you have installed our
product
• The version of the operating system that your system is running (e.g., Solaris 7)
Then fill out and mail the Product Registration Card at the back of this manual, in
order to be eligible for technical support.
TABLE 4. Installation Overview Procedures
Step Description Go to
1 Unpack the multiport controller. “Unpacking Vanguard
Hardware” on page 3-3
2 Install the card in an empty slot “Installing the Multi-
port Card” on page 3-5
3 Install the device drivers “Installing the Device
Driver Software” on
page 4-1
4 Set up port services for the asynchronous
ports
“Setting Up Asynchro-
nous Port Services” on
page 4-4
5 Install sync protocol stack (optional) Protocol Package Docu-
mentation