Filter
Top Products
Connecting to RMHost
ARM DUI 0137A Copyright © 2000 ARM Limited. All rights reserved.. All rights reserved. 29
Note
If RMHost detects an error in the configuration you have selected, an error
message is displayed. If this happens, you can click one of the following:
OK Stores the configuration, although the error can prevent you from using
RMHost.
Cancel Does not store the configuration, and you are returned to the
RealMonitor Configuration dialog box.
See Error messages on page 37 for a description of RMHost-related errors.
If configuration is successful, the selected configuration is stored, and the Choose
Target dialog box is displayed.
10. Click OK. You are ready to begin debugging your application (see Chapter 3
Debugging with RMHost).
Note
A dialog box indicating that the processor is still executing might be displayed. If
this happens, click No to indicate that you do not want execution to stop.
Caution
When switching targets using AXD, a dialog box is displayed that requests
whether you want to reload the last image. In this case, you must click No because
reloading the last image corrupts the currently running image.
If you have disabled write access to the program counter (pc) in the register
descriptor block, the message shown in Figure 2-6 is displayed (see CPU register
access on page 34).
Figure 2-6 No pc write access message
If you have disabled read access to the pc in the register descriptor block, the
message shown in Figure 2-7 on page 210 is displayed (see CPU register access
on page 34).