Filter
Top Products
Connecting to RMHost
28 Copyright © 2000 ARM Limited. All rights reserved.. All rights reserved. ARM DUI 0137A
Caution
The module server does not work with the RMHost controller if you disabled
support for the ExecuteCode packet when you built RMTarget. See the
description of the
RM_OPT_EXECUTECODE
build option in the building the RMTarget
chapter of the ARM RMTarget Integration Guide.
8. Provide the module server with information about the target system.
If RMTarget was built with this information embedded, select Fetch module
information from target and click OK to obtain this information (see the build
option
RM_OPT_SDM_INFO
in the building chapter of the ARM RMTarget Integration
Guide). If you select this option, the fields Processor and Board are grayed out,
as shown in Figure 2-4 on page 26.
If no information is returned when you select the option Fetch module
information from target and click OK, you must provide information as
follows:
a. Deselect the the option Fetch module information from target.
b. From the drop-down list in the Processor field, select the processor core
being debugged, such as
ARM966E-S
. The list consists of processors
supported by the RDI module server, including a blank entry that you must
select if the system being debugged is not included in the list. See RMHost
requirements on page 14 for details on hardware supported by the
RealMonitor host controller.
c. From the drop-down list in the Board field, select the board you are using,
such as
CM966E-S + Integrator/AP
. The list consists of boards supported by
the RDI module server, including a blank entry that you must select if the
system being debugged is not included in the list. See RMHost
requirements on page 14 for details on hardware supported by the
RealMonitor host controller.
Note
It is possible to specify only a processor without specifying a board. In this
case, only the processor state (coprocessor 15) is displayed by AXD when
the module server is enabled. If you specify only a board, and no processor,
only the state of the board peripherals is displayed by AXD when the
module server is enabled.
9. Click OK.