Filter
Top Products
Connecting to RMHost
ARM DUI 0137A Copyright © 2000 ARM Limited. All rights reserved.. All rights reserved. 27
Figure 2-5 JTAG controller search dialog box
6. Click Configure... to configure the JTAG controller you have selected. For details
on configuring Multi-ICE 2.0, see the Using Multi-ICE with Debuggers chapter
of the Multi-ICE User Guide. If you are using another JTAG controller, see its
accompanying documentation for details on configuration.
Note
Optionally, you can enable tracing if you have ARM Trace Debug Tools (TDT)
installed. For details on enabling tracing, see the appendix on setting up the trace
software in the Trace Debug Tools User Guide.
When you have successfully configured the JTAG controller, the RealMonitor
Configuration dialog box is redisplayed.
7. Optionally, you can enable use of the RDI module server. The RDI module server
implements the host-side of the Self-Describing Module (SDM) extension to the
RDI (see the build option
RM_OPT_SDM_INFO
in the building chapter of the ARM
RMTarget Integration Guide).
If you do not want to enable this feature, deselect Use RDI Module Server, and
proceed to step 9.
Enabling the RDI module server allows you, when connected to the RMHost
controller, to view the entries in the registers view (of AXD) for any additional
devices you have installed in your target system, such as coprocessors and
interrupt controllers. You can view these entries by selecting Registers from the
Processor Views menu.
To enable use of the module server, select Use RDI Module Server. The option
Fetch module information from target is no longer grayed out.