A SERVICE OF

logo

RS-232 Interface
This printer is configured as Data Terminal Equipment (DTE). The serial data cable
used to connect the printer to the host computer will be one of two styles:
n
9-pin to 25-pin cable – (null modem cable) must have a 9-pin “D” type (DB-9S)
connector on the end that is plugged into the serial port at the computer and a
25-pin “D” type (DB-25P) connector on the other end that is plugged into the
connector at the rear of the printer. Figure 35 shows the required cable
connections.
25-pin to 25-pin cable – (null modem cable) must have a 25-pin “D” type (DB-25S)
connector on the end that is plugged into the serial port at the computer and a 25-pin
“D” type (DB-25P) connector on the other end that is plugged into the connector at
the rear of the printer. Figure 36 shows the required cable connections.
86 Zebra Z4M Printer User’s Guide
Figure 35
Figure 36