A SERVICE OF

logo

Leaving the Setup Mode
You can leave the program mode at any time by pressing the SETUP/EXIT key. The
“SAVE CHANGES” display will appear. There are five choices, described below.
Pressing the INCREMENT (+) or DECREMENT (-) key displays other choices and
pressing the SELECT key selects the displayed choice.
n
PERMANENT -- Permanently saves the changes. Values are stored in the printer
even when power is turned off.
n
TEMPORARY -- Saves the changes until changed again or until power is turned
off.
n
CANCEL -- Cancels all changes since pressing the SETUP/EXIT key except the
darkness and tear-off settings (if they were changed).
n
LOAD DEFAULTS -- Loads factory defaults.
n
LOAD LAST SAVE -- Loads values from the last permanent save.
Zebra Z4M Printer User’s Guide 39