A SERVICE OF

logo

Open as PDF
next previous
CANCEL Key Self Test
This self test prints a listing of the configuration
parameters currently stored in the printer’s
memory. See Figure 29. (Depending on the
options ordered, your label may look different.)
1. Turn off the printer.
2. Press and hold the CANCEL key while
turning on the power.
3. Release the key after the DATA light turns
off (approximately five seconds).
The configuration may be changed either
temporarily (for specific label formats or ribbon
and label stock) or permanently (by saving the
new parameters in memory). Refer to page 15
for further information about the configuration
procedure.
74 Zebra Z4M Printer User’s Guide
Figure 29