Power Rewind Media Alignment
(Power rewind option required.)
NOTE: Under normal operating conditions, media alignment should
not be necessary if the media/backing was initially installed tightly
against the backplate of the take-up spindle.
Perform the following adjustment if the media does not track properly onto the
take-up spindle.
Refer to Figure 28.
1. With media and backing material loaded, open the printhead assembly.
2. Turn the adjustment dial clockwise to align the media/backing material more to
the right. (The image will move to the left.)
or
Turn the dial counterclockwise to align the media/backing material more to the
left. (The image will move to the right.)
3. Manually rotate the take-up spindle and ensure the media/backing tracks
properly.
4. Close the printhead assembly.
64 Zebra Z4M Printer User’s Guide
