Network Configuration Worksheets
A-27
8000-A2-GB21-30
April 1998
RTU Static Routes Screen A-H-C
Prompt Your Configuration Setting
4. Do one of the following at the at the
DSLAM yes/no: prompt.
– Enter yes to automatically create
the corresponding DSLAM route for
the end system.
– Enter no to not automatically create
the corresponding DSLAM route for
the end-system.
DSLAM = Yes
5. When the system highlights Save
Changes?, enter yes at the yes/no:
prompt.
NOTE:
When the 8546 card is upgraded to the latest software that supports the
A-H-B and A-H-C screens, the card will automatically retrieve the RTU
configuration from the 5446 RTU, provided that the 5446 RTU has first been
upgraded to the latest software.
If the 8546 card is upgraded prior to the upgrade of the 5446 RTU endpoints,
then the A-H-B and A-H-C screens (for those DSL ports), are not applicable.
However, the 8546 card will automatically retrieve the RTU configuration
information upon upgrading the 5446 RTU to the latest software.
CAUTION:
For the latest revision 5446 RTU, the RTU configuration cannot be
modified by an external SNMP Manager or the Paradyne IP Injection
tool. Also, the RTU configuration of older revision 5446 RTU endpoints
should not be modified by an SNMP Manager or the Paradyne IP
Injection tool. If modified, the 8546 card may not be able to
automatically retrieve the RTU configuration information upon
upgrading the 5446 RTU to the latest software.
