40
Chapter 3: Menus
Auto Continue Disabled*
5…255
Set Auto Continue to a value between 5 seconds and 255 seconds to have the printer
automatically continue operating after it detects one of the following errors:
35 Res Save Off Deficient Memory
37 Insufficient Collation Area
37 Insufficient Defrag Memory
37 Insufficient Memory
38 Memory Full
39 Complex Page
51 Defective Flash
52 Flash Full
53 Unformatted Flash
54 Serial Option x Error
54 Std Par ENA Connection Lost
54 Par x ENA Connection Lost
54 Ser x Fax Connection Lost
55 Insufficient Fax Buffer
56 Std Parallel Port Disabled
56 Parallel Port
x
Disabled
56 Serial
x
Port Disabled
61 Defective Disk
62 Disk Full
63 Unformatted Disk
84 Transfer Belt Life Warning
85 Coating Roll Life Warning
87 Fuser Exhausted
88 Yellow Toner Low
88 Magenta Toner Low
88 Cyan Toner Low
88 Black Toner Low
Print Jobs on Disk?
If one of these errors occurs and Auto Continue is
disabled, the printer stops and waits for
operator intervention. When Auto Continue
is set to a numerical value, the printer waits for
operator intervention for the specified length of time and then automatically resumes
processing.
The Auto Continue value has one other purpose. If the operator panel has displayed menu
information for the specified period of time without a button being pressed, the printer
automatically exits the menus and returns to the ready state.
Setup Menu (continued)
Menu item Values
*Factory default
