106
Chapter 6: Loading paper in the trays
Note:
If you load transparen-
cies in tray 1 or the multipurpose
feeder, make sure you change
the Paper Type setting to trans-
parencies for that location.
If you attached an optional drawer unit, the instructions
are the same for loading paper in those trays. However,
load only paper in those trays.
To load the tray:
1 Pull the paper tray completely out of the printer.
2 Set the paper tray on a flat surface.
Note:
If you are loading A4
or letter size paper, the tray
may already be set up for the
appropriate paper size.
3 Squeeze the snap lock on the end of the rear paper
guide.
4 Lift the rear paper guide from the tray.
5 Align the rear paper guide with the position for
the paper size you are loading.
