39
Chapter 3: Menus
Resource Save Off*
On
The Resource Save setting determines what the printer does with resources downloaded to
RAM if the printer receives a job that requires more memory than is available.
If
Resource Save is On, the printer retains all permanent downloaded resources for all printer
languages during language changes and printer resets. If the printer runs out of memory, the
message
Memory Full
appears on the display.
If Resource Save
is Off, the printer retains permanent downloaded resources only until
memory is needed. Your printer deletes those resources stored for the inactive printer
language.
See page 90 for information about adding memory to your printer.
Note:
Resource Save requires a minimum amount of available memory. If there is not
sufficient memory available, the printer posts
insufficient memory
and automatically sets
Resource Save to off.
Download Target RAM*
Flash
Disk
The Download Target menu item specifies
where you want to store downloaded resources.
Storing downloaded resources in flash memory or an optional hard disk is permanent storage
rather than the temporary storage that RAM provides. You can add resources to flash memory
or disk until the device is full. Use your software application or the MarkVision printer utility to
download resources to the printer.
The Download Target menu item is only displayed if the flash memory or hard disk is not
defective or Read/Write or Write protected. Disk is not an available value for Download Target
if Job Buffer Size is set to 100%.
Print Timeout Disabled
1…255 (90*)
The Print Timeout setting determines the time (from 1 to 255 seconds) the printer waits before
printing the last page of a print job that does not end with a command to print the page. The
print timeout counter does not start until the printer displays the
Waiting
message.
When a print timeout occurs, the printer stores the page in the print buffer.
When Print Timeout is disabled, the printer does not print the last page of a print job until one
of the following occurs:
• The printer receives enough information to fill the page.
• The printer receives a Form Feed command.
• You select Print Buffer from the Job Menu. See page 35 for more information.
Setup Menu (continued)
Menu item Values
*Factory default
