Filter
Top Products
RE-ASSIGNING DEVICE KEYS
The Millennium 4 can be set up to control a second TV
or VCR, or any combination of four home entertainment
components.For example,to have the Millennium 4
control a TV, a Cable Converter,and two VCRs,you will
need to re-assign the unused AUDIO key to operate the
second VCR as follows:
1. On the Millennium 4,press and hold SETUP
until the LED blinks twice,then release SETUP.
2. Enter 9 - 9 - 2.The LED will blink twice.
3. Press VCR once, then press AUDIO once.
4. The AUDIO key is now ready to be programmed
for your second VCR. See Programming
VCR/DVD Player Control on page 12.
To re-assign other device keys,repeat steps 1 through 4 by
substituting the key sequence from the following chart for
a desired component:
To Re-Assign Perform Key Sequence
TV as 2nd VCR key: SETUP - 9 - 9 - 2 - VCR - TV
TV as 2nd Audio key: SETUP - 9 - 9 - 2 - AUDIO - TV
TV as 2nd Cable key: SETUP - 9 - 9 - 2 - CBL - TV
TV back to TV: SETUP - 9 - 9 - 2 - TV - TV
VCR as 2nd TV key: SETUP - 9 - 9 - 2 - TV - VCR
VCR as 2nd Audio key: SETUP - 9 - 9 - 2- AUDIO - VCR
VCR as 2nd Cable key: SETUP - 9 - 9 - 2 - CBL - VCR
VCR back to VCR: SETUP - 9 - 9 - 2 - VCR - VCR
AUDIO as 2nd TV key: SETUP - 9 - 9 - 2 - TV - AUDIO
AUDIO as 2nd VCR key: SETUP - 9 - 9 - 2- VCR - AUDIO
AUDIO
as 2nd Cable key:
SETUP - 9 - 9 - 2 - CBL - AUDIO
AUDIO
back to
AUDIO
:
SETUP - 9 - 9 - 2 - AUDIO - AUDIO
Upon completion of a re-assignment,the LED will blink
twice to confirm your selection.At that time,you will also
need to program the Millennium 4 to control the new
component.See previous sections on Programming TV
Control,Programming VCR/DVD Player Control,
Programming Cable Converter (or DBS Receiver) Control,
or Programming Audio Control.
26
Millennium 4 Mnl M4092 rev 1/22/03 9:38 AM Page 26