Filter
Top Products
PROGRAMMING AUDIO CONTROL
Locate the brand name of your audio amplifier or receiver
in one of the accompanying code lists at the end of this
section.Write it in the appropriate space below.
Audio Amplifier Brand: ________________________
or
Audio Receiver Brand:__________________________
The brands are listed in alphabetical order with popular
codes listed first.You will use one of these codes to
program the Millennium 4 to operate your audio device:
1. Turn on the audio device.
2. On the Millennium 4,press AUDIO once. Press
and hold SETUP until the LED blinks twice,
then release SETUP.
3. Enter the first four-digit code for your audio
device.If you perform this procedure correctly,
the LED will blink twice.
NOTE:If the LED did not blink twice after entering
the code’s last digit,then repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Millennium 4 at your audio device and
press POWER once.The unit should turn off.If
it does not respond,repeat steps 2 and 3,trying
each code listed for your brand until you find
one that works.If it still does not work ,try
searching for the code (see Searching For Your
Code on page 24).
5. For future reference,write your device’s code
and type in the boxes and space below.
NOTE:Remember, to use the Millennium 4 to operate your audio
device, press AUDIO first.
Setup Codes for Audio Amplifiers:
Denon 0160
GE 0078
Harman/Kardon 0892
JVC 0331
Marantz 0892
22
Millennium 4 Mnl M4092 rev 1/22/03 9:38 AM Page 22