Filter
Top Products
CHECKING THE CODES
If you have set up the Millennium 4 using the Searching
For Your Code procedure,you may need to find out which
four-digit code is operating your equipment:
For example,to find out which code is operating your TV:
1. Turn on your TV.
2. On the Millennium 4,press and hold SETUP
until the LED blinks twice,then release SETUP.
3. Enter 9 - 9 - 0.The LED will blink twice.
4. To view the code for the first digit,press 1 once.
Wait 3 seconds and count the number of LED
blinks (e.g.,3 blinks = 3) and write down the
number in the leftmost TV Code box below.
NOTE:If a code digit is “0”,the LED will not blink.
5. Repeat step 4 three more times for remaining
digits.Use 2 for the second digit,3 for the third
digit,and 4 for the fourth digit.Finish writing
down the code in the TV Code boxes below.
6. To check for the codes of your other
components,repeat steps 1 through 5,but
substitute the appropriate key (i.e.,VCR,CBL,
or AUDIO) for the (VCR or DVD,Cable,or
Audio) component you are checking.Write
down the codes in the appropriate boxes below.
TV Code
VCR (or DVD Player) Code
CBL Code
AUDIO ___________________ Code
25
Millennium 4 Mnl M4092 rev 1/22/03 9:38 AM Page 25