Filter
Top Products
PROGRAMMING VCR/DVD PLAYER CONTROL
NOTE:If you own a TV/VCR combination,skip this section and
perform “Programming TV/VCR Combo Control”on page 16.
Locate the brand name of your VCR in Setup Codes for
VCRs on the next page,or your DVD player in Setup Codes
for DVD Players on page 15,and write it in the appropriate
space below.
VCR Brand:________________________________
or
DVD Player Brand: ____________________________
The brands are listed in alphabetical order with the most
popular codes listed first.You will use one of these codes
to program the Millennium 4 to operate your VCR or
DVD player:
1. Turn on your VCR and insert a video cassette,
or turn on your DVD player and insert a DVD.
2. On the Millennium 4,press VCR once. Press
and hold SETUP until the LED blinks twice,
then release SETUP.
3. Enter the first four-digit code for your VCR or
DVD player.If you perform this procedure
correctly, the LED will blink twice.
NOTE:If the LED did not blink twice after entering
the code’s last digit,then repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Millennium 4 at the VCR or DVD
player and press POWER once.The device
should turn off.If your VCR remote control
does not have a POWER key,press PLAY.Ifthe
VCR does not respond,repeat steps 2 and 3,
trying each code listed for your brand until you
find one that works.If the device still does not
work ,try searching for the code (see Searching
For Your Code on page 24).
5. For future reference,write your device’s code
and type in the boxes and space below.
Device Type:________________________
NOTE:Remember, to use the Millennium 4 to operate your VCR
or DVD player,press VCR first.
12
Millennium 4 Mnl M4092 rev 1/22/03 9:38 AM Page 12