Filter
Top Products
NOTE:If the LED did not blink twice after entering
the code’s last digit,then repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Millennium 4 at your TV/VCR Combo
and press POWER once.The unit should turn
off.If it does not respond,repeat steps 2 and 3,
trying each code listed for your brand until you
find one that works.If it still does not work,try
searching for the code (see Searching For Your
Code on page 24).
5. If you’ve found a TV/VCR setup code that works
your TV/VCR Combo and a separate TV code is
also listed,you’ll need to program this code into
the Millennium 4 to access volume control (see
Programming TV Control on page 8).
If there is no separate TV code listed,you will
need to perform the following steps to access
volume control:
a. Press and hold SETUP until the LED blinks
twice,then release SETUP.
b. Enter 9 - 9 - 3.The LED will blink twice.
c. Press VCR once.The LED will blink twice.
6. For future reference,write your TV/VCR
Combo code in the boxes below.
NOTE:Remember, to use the Millennium 4 to operate your
TV/VCR Combo,press VCR first.
Setup Codes for TV/VCR Combos:
American High 0035 (for TV use 0051)
Brocksonic 0002,0294,
Colt 0072
Curtis Mathis 0035 (for TV use 0051)
Daewoo 0278
Emerson 0002, 0294,0479
Funai 0000
GE 0035 (for TV use 0051),0060 (for TV use 0047),
0048 (for TV use 0093),0240
Hitachi 0035 (for TV use 0051),0000
HQ 0000
Lloyds 0000
MGA 0240
Magnavox 0081 (for TV use 0054),0035 (for TV use 0051),0000
continued on next page...
17
Millennium 4 Mnl M4092 rev 1/22/03 9:38 AM Page 17